Inovance MD500-EN1 - Interface Layout and Description

1 Product Information
- 10 -
1.4 Interface Layout and Description
"Figure 1-3 MD500-EN1 interface layout"shows the hardware layout of the MD500-EN1
card. The pin header J7 on the back of the MD500-EN1 card is used to connect the AC
drive. The MD500-EN1 card provides two network ports J4 and J6 for communication
with Ethernet/IP master (or other slaves). For details about the hardware, see"Table 1-1
Interface Description".
+
+
+
%
%
%
%
+
Figure 1-3 MD500-EN1 interface layout
Table 1-1 Interface Description
Symbol Interface Name Function Description
J7 Pin header Used to connect the AC drive.
J4
Network port
Adopts the standard Ethernet RJ45 socket,
direction insensitive. Used for MD500-EN1 card
to establish communication with Ethernet/IP
master station(or other slave stations). Its pin
signal de󶍾nitions are the same as those of the
standard Ethernet pins. They can be connected
using crossover cables or straight-through
cables.
J6
J1 EMC ground terminal
Used to connect the EMC ground terminal of
the AC drive.
D13
Power indicator
(green)
Used to indicate the power status.
On: normal
O󶍽: abnormal (Check whether the installation
is correct).