Inovance MD500-EN1 - Page 19

4 Parameters Related to Communication
- 18 -
Parameter No. Parameter Name Setting Range Description
FD-42
to
FD-45
Subnet mask of
expansion card
0-255
Used to set subnet mask of
Ethernet/IP expansion card.
FD-46
to
FD-49
Gateway address of
expansion card
0-255
Used to set gateway address of
Ethernet/IP expansion card.
IP address setting is divided into static IP and DHCP dynamic IP address. Select the IP
mode in parameter No. FD-37. Set static IP address in parameter No. FD-37 to FD-49.
For example, con󶍾gure static IP address :192.168.0.6 , subnet mask:255.255.255.0, and
gateway address:192.168.0.1, set the following parameters.
Parameter No. Function
Set Value
FD-37 DHCP function selection
0
FD-38 Most signi󶍾cant byte of the IP address
192
FD-39
Second most signi󶍾cant byte of the
IP address
168
FD-40
Third most signi󶍾cant byte of the IP
address
0
FD-41 Least signi󶍾cant byte of the IP address
6
FD-42
Most signi󶍾cant byte of the subnet
mask
255
FD-43
Second most signi󶍾cant byte of the
subnet mask
255
FD-44
Third most significant byte of the
subnet mask
255
FD-45
Least signi󶍾cant byte of the subnet
mask
0
FD-46 Most signi󶍾cant byte of the gateway
192
FD-47
Second most signi󶍾cant byte of the
gateway
168
FD-48
Third most signi󶍾cant byte of the
gateway
0
FD-49 Least signi󶍾cant byte of the gateway
1
View MAC address when DHCP/BOOTP function is used. To view the MAC address,
read the label attached to the expansion card or check the related parameter (see "4.3
Parameters of AC Drive Communication Card" for details).
This card supports IP address con󶍿ict detection. When other devices in the network
share the same IP address with the expansion card, D7 indicator will be steady ON and
bit2 of FD-58 will be changed to 1.
The following three cases are present in IP address con󶍿ict detection.