Inovance MD500-EN1 - Page 22

4 Parameters Related to Communication
- 21 -
Parameter
No.
Name Unit Decimal Address
U0-13 Length value 1 28685
U0-14 Load speed display 0.001 Hz 28686
U0-15 PID reference 1 28687
U0-16 PID feedback 1 28688
U0-17 PLC stage 1 28689
U0-18 Pulse input reference (Hz) 0.01 kHz 28690
U0-19 Feedback speed (Hz) 0.01 Hz 28691
U0-20 Remaining operating time 0.1 min 28692
U0-21 AI1 voltage before correction 0.001 V 28693
U0-22 AI2 voltage before correction 0.001 V 28694
U0-23 AI3 voltage before correction 0.001 V 28695
U0-24 Linear speed 1 m/min 28696
U0-25 Current power-on time 1 min 28697
U0-26 Current operating time 0.1 min 28698
U0-27 Pulse input frequency 1 Hz 28699
U0-28 Communication reference 0.01% 28700
U0-29 Encoder feedback speed 0.01 Hz 28701
U0-30 Display of main frequency X 0.01 Hz 28702
U0-31 Display of auxiliary frequency Y 0.01 Hz 28703
U0-32 Check on any memory address 1 28704
U0-33 Synchronous motor rotor position 0.1° 28705
U0-34 Motor temperature 1℃ 28706
U0-35 Target torque (%) 0.1% 28707
U0-36 Resolver position 1 28708
U0-37 Power factor angle 0.1° 28709
U0-38 ABZ position 1 28710
U0-39 Target voltage upon V/f separation 1 V 28711
U0-40 Output voltage upon V/f separation 1 V 28712
U0-41 DI state display 1 28713
U0-42 DO state display 1 28714
U0-43 DI state display 1 1 28715
U0-44 DI state display 2 1 28716
U0-45 Fault information 1 28717
U0-58 Z signal counting 1 28730
U0-59 Rated frequency (%) 0.01% 28731
U0-60 Operating frequency (%) 0.01% 28732