Inovance MD500-EN1 - Page 5

Safety Instructions
- 4 -
WARNING
◆
Do not install the equipment if you 󶍾nd damage, rust, or indications of use on the
equipment or accessories.
◆
Do not install the equipment if you 󶍾nd water seepage, component missing or damage
upon unpacking.
◆
Do not install the equipment if you 󶍾nd the packing list does not conform to the
equipment you received.
Storage and Transportation
CAUTION
◆
Store and transport this equipment based on the storage and transportation
requirements for humidity and temperature.
◆
Avoid transporting the equipment in environments such as water splashing, rain, direct
sunlight, strong electric 󶍾eld, strong magnetic 󶍾eld, and strong vibration.
◆
Avoid storing this equipment for more than three months. Long-term storage requires
stricter protection and necessary inspections.
◆
Pack the equipment strictly before transportation. Use a sealed box for long-distance
transportation.
◆
Never transport this equipment with other equipment or materials that may harm or
have negative impacts on this equipment.
WARNING
◆
Use professional loading and unloading equipment to carry large-scale or heavy
equipment.
◆
When carrying this equipment with bare hands, hold the equipment casing 󶍾rmly with
care to prevent parts falling. Failure to comply may result in personal injuries.
◆
Handle the equipment with care during transportation and mind your step to prevent
personal injuries or equipment damage.
◆
Never stand or stay below the equipment when the equipment is lifted by hoisting
equipment.
Installation
WARNING
◆
Thoroughly read the safety instructions and user guide before installation.
◆
Do not modify this equipment.
◆
Do not rotate the equipment components or loosen 󶍾xed bolts (especially those marked
in red) on equipment components.
◆
Do not install this equipment in places with strong electric or magnetic 󶍾elds.
◆
When this equipment is installed in a cabinet or 󶍾nal equipment, protection measures
such as a 󶍾reproof enclosure, electrical enclosure, or mechanical enclosure must be
provided. The IP rating must meet IEC standards and local laws and regulations.