Compliance
‑149‑
● This product conforms to the Low Voltage Directive (LVD), Electromagnetic
Compatibility (EMC) Directive, and Restriction of Hazardous Substances (RoHS)
Directive, and is therefore marked with CE.
● Machines and devices integrated with this product must also be CE certified for
distribution in Europe.
● The integrator who integrates this product into other products and attaches CE
mark to the final assembly has the responsibility of ensuring compliance with CE
certification.
9.2.2 Requirement for Compliance with EMC Directive
● The drive is applicable to the first and second environment and complies with EMC
directive 2014/30/EU and standard EN IEC 618003.
When applied in the first environment, this product may generate radio interference. Be‑
sides the CE compliance, take measures to avoid the radio interference if required.
● To enable the drive to comply with the EMC directive and standard, install an EMC
filter on the input side and use shielded cables on the output side. Ground the
filter properly and ground the shield of the output cable 360 degrees.
Manufacturers of systems integrating with this product are responsible for system compli‑
ance with the European EMC directive and EN IEC 61800‑3 requirements in different system
application environments.
EMC specifications
Observe the product requirements during installation. This product meets the
requirements of the EN IEC 61800‑3 standard. Limit the motor cable length in
accordance with the following table to avoid impact of conduction and radiation
interference.
To Next Page
Loading...
