10
IS-NXT10232 Designer shelf system
www.insignia-products.com
USING THE VARIABLE BASS CONTROL (REMOTE CONTROL
ONLY)
To use the variable bass control:
1 Press the BASS + or - button on the remote
control to increase or decrease the amount of
bass response from the subwoofer speaker.
U
SING THE MUTE BUTTON (REMOTE CONTROL ONLY)
To use the Mute button:
1 To temporarily turn off the sound from the
speakers, press the MUTE button on the
remote control. The display will begin flashing
and the sound will turn off.
2 Press the MUTE button again to cancel Mute
and restore the sound. The message will stop
flashing from the display.
Listening to the radio
To listen to the radio:
1 Press the STANDBY/ON button. The main
display turns on.
2 Press the FUNCTION button repeatedly to
switch to Tuner mode.
The display will show an AM or FM station
frequency.
3 To select a different band (AM or FM), press
the AM/FM button on the front panel or the
STOP/BAND button on the remote control.
4 Tune to the frequency, as follows:
• Manual Tuning—Repeatedly press either
the TUNE/SKIP > or < button until the
frequency of the station you want appears
on the display.
• Automatic Tuning—Press and hold the
TUNE/SKIP > or < button until the display
begins to move, then release the button.
The tuner will search up or down the
frequencies for the next strong station and
stop on that station. Repeat this
procedure until the tuner stops on your
station.
Pre-setting stations in the tuner memory
This system includes a 20-station preset
memory. You can store up to 10 FM stations and
10 AM stations in the tuner memory for
immediate recall.
To store stations in memory:
1 Tune the radio frequency you want.
Example: FM 103.5 MHz.
2 When the station appears on the display,
press the CLOCK/PROG button. The
“PROGRAM” indicator appears and Preset
Memory Number “01” flashes in the display.
3 Press the PRE/ALB + or - button to select the
memory number.
In this case, choose “01” as the memory
number.
Note
The control is set to “0” as the default level.
The range is from “-4” (minimum) to “+4”
(maximum).
Note
The looping order of the FUNCTION button
is: TUNER>CD>AUX.
Note
Pressing the ST/MO/FIND button on the
remote control (only) switches between
Stereo and Mono sound modes. If the
reception is noisy or weak, press the button
to change to the mono setting (the Stereo
indicator will disappear). The reception will
normally improve, but the sound will no
longer be in stereo.
NXT Designer shelf system - combined.fm Page 10 Wednesday, July 6, 2005 9:04 AM
To Next Page
Loading...
