3
IS-NXT10232 Designer shelf system
www.insignia-products.com
Preparing to set up your
system
Unpacking and setup
This system consists of the following
components:
• Tuner/CD player unit
• Amplifier/subwoofer unit
• 2 NXT flat panel speakers
• Remote control
Carefully remove all the components from the
display carton and verify that you have all the
necessary components before you dispose of
the carton.
• Remove all packing materials from the
individual components.
• Remove any descriptive labels that may be
attached to the front panel of the main unit.
• Do not remove any labels or stickers on the
back panels of the main unit or the speakers.
• Remove any small strips of tape that may
have been used to prevent the CD door from
opening in transit.
• Place all the components in the location you
want. This system is designed to be used on
a level, stable, flat surface, such as a table,
desk, shelf, or stand convenient to an AC
outlet, out of direct sunlight, and away from
sources of excess heat, dust, moisture, or
vibration.
• Unwind the AC power cord on the back of the
amplifier/subwoofer unit and extend the cord
to its full length.
• Unwind the lead wire FM antenna on the
back of the tuner/CD player unit and extend it
to its full length.
• The main unit is shipped with a dummy CD
display card in the CD player. This dummy
CD card must be removed before you can
use the CD player. Refer to “Playing CDs” on
page 11.
Power source
This system is designed to operate on 120V AC
60Hz house current only.
Connecting this system to any other power
source may cause damage to the system. This
type of damage is not covered by your warranty.
Main power switch
Warning
The system uses a polarized AC plug with
one wide blade and one narrow blade. The
plug will only fit into matching polarized AC
outlets. This is a safety feature to reduce the
possibility of electric shock. If the plug will
not fit in your AC outlets, you probably have
outdated, non-polarized outlets. You should
have your outdated outlets changed by a
qualified, licensed electrician. Do not file the
wide blade on the plug or use an adapter to
make the plug fit into your outlet. This
defeats the safety feature and could expose
you to electric shock.
Note
The main power switch is located on the
back of the amplifier/subwoofer unit. This
switch must be 'On' for the system to
operate. The main power switch should be
left in the On position at all times. The only
time you should set this switch back to the
Off position is if you will not be using the
system for an extended period of time - for
example, two weeks or longer. The remote
control cannot operate the system if the
main power switch is in the Off position.
To Next Page
Loading...
Need help?
General
