4
IS-NXT10232 Designer shelf system
www.insignia-products.com
Setting up your system
System connections
Connect the tuner/CD player unit and the
amplifier/subwoofer unit with the supplied 9-pin
cable. Attach one end of the cable to the “TO
SUBWOOFER” jack of the tuner/CD player and
attach the other end to the “FROM MAIN” jack of
the amplifier/subwoofer.
Speaker connections
Connect the two NXT flat panel speakers to the
color-coded white “L” and red “R” speaker jacks
on the back of the amplifier/subwoofer unit.
Make sure that the speaker plugs are fully
inserted into the speaker jacks. If the plugs are
loose, the connection may be intermittent.
Auxiliary source connections
You can listen to the sound from external audio
sources through the speakers of this system. To
do this, connect the aux/line/audio output jacks
of the external audio source to the AUX IN jack
at the back panel of amplifier/subwoofer unit.
Examples of external audio sources that can be
connected to this system include cassette
players, mini disc players, or the sound from your
TV, VCR, or DVD player.
Instructions for listening to external audio
sources will be found later in this manual.
Antennas
FM
Make sure the FM lead wire antenna is unwound
and extended to its full length. It may be
necessary to vary the direction of this wire
antenna until you find the position that provides
the best reception for your favorite FM stations.
AM
The AM ferrite bar antenna is inside the tuner/
CD player unit. If AM reception is unsatisfactory,
you may have to turn the main unit slightly until
you find the position that provides the best
reception.
Caution
When inserting the DIN cable, the arrows on
the ends of the cable must be aligned with
the arrows on the units. Misalignment may
cause the connectors to fail or damage the
9-pin cable.
To Next Page
Loading...
Need help?
General
