5
IS-NXT10232 Designer shelf system
www.insignia-products.com
Remote control battery
The remote control requires one button-type
3-volt lithium battery (included). To extend the
life of the original battery we have inserted a
small clear plastic spacer tab between the
lithium battery and the battery terminal. You
must remove this spacer tab before you can use
the remote control. To remove the tab, pull it in
the direction of the arrow.
When the operation of the remote control
becomes intermittent or unsatisfactory, replace
the original battery with a new 3-volt lithium
battery.
To replace the battery:
1 Press the locking lid of the battery holder to
the left and slide the battery holder out.
2 Place one 3V CR2032 battery in the battery
holder, with the positive (+) side up. If the
battery is placed incorrectly the remote
control will not work.
3 Insert the battery holder into the battery slot
until it clicks into place.
Protect your furniture
This system is equipped with non-skid rubber
“
feet
” to prevent the system from moving when
you operate the controls. These feet are made of
non-migrating rubber material, specially
formulated to avoid leaving any marks or stains
on your furniture. However, certain types of
oil-based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber feet to
soften and leave marks or a rubber residue on
the furniture. To prevent any damage to your
furniture, we strongly recommend that you
purchase small self-adhesive felt pads, available
at hardware stores and home improvement
centers, and apply these pads to the bottom of
the rubber feet before you place the product on
fine wooden furniture.
Note
Use a well-known brand of battery for
longest life and best performance. When the
operation of the remote control becomes
intermittent, replace the battery.
NXT Designer shelf system - combined.fm Page 5 Wednesday, July 6, 2005 9:04 AM
To Next Page
Loading...
Need help?
General
