Insignia IS-NXT10232 - Auxiliary Sources, Maintenance, and Warranty; Connecting and Listening to Auxiliary Sources; CD Care and Cabinet Cleaning; Limited Warranty Information

16
IS-NXT10232 Designer shelf system
www.insignia-products.com
7 Press the TIMER button again. The Minute
digits begin flashing.
8 Press the SKIP/TUNE > or < buttons to set
the display to the turn-off minute you want.
9 Press the TIMER button again. The “TUNER”
message begins flashing.
10 Press the SKIP/TUNE > or < buttons to
switch the Timer operating mode between
“TUNER” and “CD.”
11 Press the TIMER button again. The
“VOLUME” message begins flashing.
12 Press the SKIP/TUNE > or < button to select
the Timer operating volume.
13 Press the TIMER button again to save the
Timer settings. The saved settings will
appear on the display. The Timer function will
be activated automatically. The “TIMER”
indicator shows on the display once the
Timer function is activated.
At the selected turn-on time, the system will
turn on automatically to the function selected:
either TUNER or CD. The “TIMER” indicator
remains in the display. The unit will shut off
automatically at the selected turn-off time.
Sleep timer
This system includes a programmable sleep
timer that lets you fall asleep to between 00 and
90 minutes of music, then shuts the power off
automatically.
To operate the sleep timer:
1 Turn the system on and operate either the
TUNER, CD, or AUX function as usual.
2 Press the SLEEP button once. The display
will show “SLEEP 90."
3 Press the SLEEP button to adjust the amount
of sleep timer operation.
Each time you press the SLEEP button to
adjust the sleep time, it reduces the time by
10 minutes.
4 Stop pressing the button when the display
shows the amount of sleep time you want,
then wait until the display returns to the
previous mode. The display returns to the
correct time, shows TUNER, CD, or AUX,
and indicates “SLEEP.”
5 Press the SLEEP button once to check the
remaining countdown.
When the Sleep Timer counts down to “00,”
the power shuts off automatically.
Note
If the turn-off time is equal to the turn-on
time, an “ERROR” message appears on the
display. Re-enter the turn-off time after the
“ERROR” message disappears.
Note
If the system turns on to the CD function, it
will only play until the end of the disc and
then stop.
Note
• As long as the “TIMER” indicator
remains in the display, the timer will
turn the system on every day at the
same time.
• To deactivate the timer, press the
TIMER button. The “TIMER” indicator
disappears from the display.
• To reactivate the timer, press the
TIMER button again. The “TIMER”
indicator reappears in the display.
• To change the saved Timer setting,
press and hold the TIMER button for
about one second. Follow the above
steps to save a new Timer setting.
Note
• You can shut the unit off manually
before the Sleep Timer counts down to
“00” by pressing the STANDBY/ON
button at any time.
• If you are falling asleep to a CD, the
system will only operate until the CD
ends. If you set the Sleep Timer for 90
minutes but your CD is only 45
minutes long, the music will stop after
45 minutes but the unit will stay on
until the Sleep Time lapses.
• To cancel the Sleep Timer, press the
TIMER button repeatedly to the “00”.
The Sleep Timer is canceled, and the
display returns to the previous mode.
NXT Designer shelf system - combined.fm Page 16 Wednesday, July 6, 2005 9:04 AM