Insignia NS-28E200NA14 User Manual

33
Insignia 28" LED TV
www.insigniaproducts.com
Using analog audio
When a home theater system is connected to the /AUDIO OUT jack, the TV speakers are muted.
To connect a home theater system using analog audio:
1 Make sure that your TV’s power cord is unplugged and the home theater system is turned off.
2 Connect a 3.5mm audio cable (not provided) to the /AUDIO OUT jack on the side of your TV and to the
AUDIO IN jacks on the analog home theater system.
3 Plug your TV’s power cord into a power outlet, then turn on your TV and the home theater system.
Notes
• For information about selecting the audio out mode for a home theater,
see the Headphone/Audio Out option in “Adjusting sound settings” on
page 44.
• You can connect headphones, an amplifier, a home theater system, or a
sound bar to the /AUDIO OUT jack. If you want to use headphones,
you need to disconnect the amplifier, home theater system, or sound
bar.
3.5mm audio cable
Home theater system
Side of TV
3.5mm audio
cable connector
/AUDIO OUT
jack
On your TV

Insignia NS-28E200NA14 Specifications

General

Brand	Insignia
Model	NS-28E200NA14
Category	LED TV
Language	English