15
115-Can Beverage Cooler
www.insigniaproducts.com
Moving your beverage cooler
1 Turn off your cooler and unplug it from the wall outlet.
2 Remove all beverages.
3 Securely tape down all loose items inside your cooler.
4 Tape the door shut.
Tips on saving energy
• Locate your cooler in the coolest area of the room, away from heat-producing
appliances or heating ducts, and out of direct sunlight.
• Do not overload your cooler. It forces the compressor to run longer.
• Do not open the door too often, especially if the weather is hot. Close the door
as soon as possible to prevent cool air from escaping.
• Make sure that the door seals completely to keep your cooler running
efficiently.
• Make sure that your cooler is sufficiently ventilated, with adequate air
circulation behind it.
Troubleshooting
Error codes
If a fault is detected, the display shows one of the following codes:
• E1: Temperature sensor fault
• E4: Defrost sensor fault
If any of these error codes appears on the display, contact your local dealer or
service center. Do not try to repair your cooler yourself.
Note: Make sure that your cooler stays in the upright position during
transportation.
PROBLEM SOLUTION
My cooler does not operate. • Make sure that your cooler is plugged in and that
the plug is pushed completely into the outlet.
• Check the house fuse or circuit breaker box and
replace the fuse or reset the circuit breaker.
• If a power failure occurs, your cooler turns off. Wait
until the power is restored, then turn it on again.
My cooler door does not
close completely.
• Adjust the shelf correctly.
• Clean the door gaskets.
• Level your cooler with the leveling feet.
My cooler is not cold
enough.
• Make sure that the door is closed correctly.
• Allow time for new beverages to cool, then check
again.
• Set the control to a colder setting.
My cooler makes unusual
noises or vibrates.
• Level the cooler with the leveling feet.
• Move your cooler out from the wall.
•This is normal.
To Next Page
Loading...
Need help?
General
