8
www.insigniaproducts.com
• Avoid placing your cooler in moist areas.
• Your cooler is not designed to be installed in an RV or used with an inverter.
• Do not stack your cooler.
• For your cooler to operate normally, avoid placing it in areas with high
magnetic fields or high humidity.
Leveling your cooler
• Your cooler must be level in order to function correctly. If your cooler is not
leveled during installation, the door may not close or seal correctly, causing
cooling, frost, or moisture problems.
• To level your cooler, you may turn either leveling foot clockwise to raise that
side of your cooler or turn it counter-clockwise to lower that side.
Reversing the door
You need a 10 mm socket wrench and a Phillips screwdriver. Have someone
available to assist you in the process. Make sure that you keep all of the parts you
remove to reuse them later.
1 Make sure that your cooler is unplugged and empty.
2 Adjust the leveling feet to their highest position.
3 Use a blade to remove the rivets.
4 Use a blade to remove the hinge cover, then use a Phillips screwdriver to
remove the hinge bolts.
CAUTION: Do not lay your cooler completely flat as that could damage the
coolant system.
33.1 in. (84.2 cm)
18.9 in.
(48.0 cm)
17.3 in. (44.0 cm)
29.9 in.
(76.0 cm)
To Next Page
Loading...
Need help?
General
