11
115-Can Beverage Cooler
www.insigniaproducts.com
Grounding requirement
Your cooler must be grounded. Your cooler is equipped with a cord having a
grounding wire with a grounding plug. The plug must be inserted into an outlet
that is correctly installed and grounded.
Consult a qualified electrician or service person if the grounding instructions are
not completely understood, or if doubt exists as to whether your cooler is
correctly grounded.
Connecting to power
• Plug your cooler into a dedicated, correctly installed, grounded wall outlet.
Your cooler should be operated on a separate electrical circuit from other
operating appliances.
• Plug in and run your cooler for three to four hours before making any
temperature adjustments and before adding beverages. This allows your
cooler to reach a stable temperature.
• Do not use an extension cord with your cooler. If the power cord is too short,
have a qualified electrician install an outlet near your cooler. Use of an
extension cord can negatively affect your cooler’s performance.
Using your beverage cooler
Turning on your cooler
Press the button to turn your cooler on. The display screen and indicators blink
for three seconds and your cooler makes an audible beep, then the compressor
starts working.
You can manually set your cooler to “Standby” mode by touching the button
for approximately three seconds, provided that the control keys are unlocked and
no other setting is in effect (the display is not blinking). Repeating this action
restarts your cooler.
WARNINGS:
• Incorrect use of the grounding plug can result in a risk of electric shock.
• Do not, under any circumstances, cut or remove the third ground prong from
the supplied power cord.
CAUTION: Your cooler is not designed to be installed in an RV or used with an
inverter.
Notes:
• Check your local power source. Your cooler requires a 110 V-120 V, 60 Hz
power supply.
• Use a receptacle that accepts the grounding prong. The power cord is
equipped with a 3-prong (grounding) plug which plugs into a standard
3-prong (grounding) wall outlet to minimize the possibility of electric shock
hazard from your cooler.
• To prolong the service life of the compressor, wait for at least five minutes
before restarting your cooler after a power failure.
To Next Page
Loading...
Need help?
General
