Insignia NS-DCC5SR09 - Picture Enhancements; Adding Photo Frames to Pictures; Selecting Flash Setting for Pictures

16
Insignia NS-DCC5SR09 5 MP Digital Camcorder with 2.4" LCD Monitor Standard Definition-Blue
www.insignia-products.com
8 Press (Record/Play) to view the
two-in-one picture.
Adding photo frames to pictures
1 Press (Record/Play) to switch to record
mode.
2 Press OK. The record menu opens.
3 Press or to select Camera Mode.
4 Press T (up) or W (down) to select Photo
Frame, then press OK.
5 Press T (up) or W (down) to select a photo
frame, then press OK to select Set.
6 Press OK to save your selection and close
the menu.
Selecting the flash setting for pictures
Your camcorder has four flash settings. The flash
setting icon appears on the LCD.
To select the flash setting for pictures:
1 Press (Record/Play) to switch to record
mode.
2 Press OK. The record menu opens.
3 Press or to select Camera Mode.
4 Press T (up) or W (down) to select Flash,
then press OK.
5 Press T (up) or W (down) to select a flash
option, then press OK to save your selection
and close the menu.
A
Auto-flash—The flash fires
automatically depending on the light
conditions. Use this mode for general
photography.
On—The flash fires for every picture.
Off—Use this mode when flash
photography is prohibited or when the
subject is beyond the range of the
flash.
Red-eye reduction—The flash fires
twice right before you take the picture.
Use this mode to help eliminate red
reflection in eyes.
Note
You can also press to change the flash setting.
Note
The flash is disabled when the battery power is
low .