EasyManuals Logo

Insignia NS-DLMIC10P User Manual

Insignia NS-DLMIC10P
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
NS-DLMIC10P Universal Lapel Microphone
www.insigniaproducts.com
Troubleshooting
Specifications
Problem Solution
The microphone
does not turn on
The battery may be incorrectly oriented in the battery
compartment. Open the battery compartment and make sure the
battery is correctly installed.
The battery may be exhausted. Replace it with a new one. See the
Specifications section for compatible replacements.
The battery terminals are dirty. Open the battery compartment and
clean the terminals with a cotton swab.
The battery
discharges too
quickly
The microphone is being left on (in the Camera position). Turn off
the microphone by moving the switch to the Off/Smartphone
position.
You are using the microphone in extremely hot or cold conditions
which drains it quickly.
Too much
ambience noise is
being picked up
Make sure that the microphone is as close as possible to the subject.
A certain amount of ambient noise is unavoidable in loud
environments.
Transducer Electret condenser
Polar pattern Omni-directional
Frequency range 65 Hz ~ 18 KHz
Signal/Noise 74 dB SPL
Sensitivity -30 dB +/- 3 dB / 0 dB=1V/Pa, 1 kHz
Output impedance 1000 Ohm or less
Battery type LR44 included (compatible with LR44, 357, and SR44)
NS-DLMIC10P_15-0888_MAN_V1_ENG_Small.fm Page 11 Tuesday, December 15, 2015 2:35 PM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Insignia NS-DLMIC10P and is the answer not in the manual?

Insignia NS-DLMIC10P Specifications

General IconGeneral
BrandInsignia
ModelNS-DLMIC10P
CategoryMicrophone
LanguageEnglish