Insignia NS-DWH1SS9 Installation Guide

www.insigniaproducts.com
10
Top Control Dishwasher
Installation instructions
Step 1: Check the door balance
1 Hold the top of the dishwasher firmly.
2 Open the door slowly, then release it. If the door drops, increase the spring tension. If the door closes, decrease the
spring tension.
3 Continue moving the spring pin until the door is balanced. Adjust both springs to the same tension.
Step 2: Adjust the leveling legs
1 Move the dishwasher close to the installation location and lay it on its back.
2 Measure the installation height and the dishwasher height.
3 Extend the leveling legs out from the dishwasher base .25 in. (6.35 mm) less than the installation height.
Caution:
• Opening the door of your dishwasher before it is installed will cause it to tip forward. Do not open the door until you are ready to
install your dishwasher.
• If it is necessary to open the door, hold the top of the dishwasher securely with one hand and hold the door with the other hand.
Note: Make sure that the leveling feet are loosened before standing the dishwasher upright. They may be tight from
shipping/packaging.
Increase
Decrease
Adjust to .25 in. (6.35 mm)
less than the installation
height
Adjust to .25 in. (6.35 mm)
less than the installation
height
NS-DWH2_BS8_SS8_NS-DWR2_BS8_WH8_SS8_17-0939_Install MAN_V5_ENG.fm Page 10 Wednesday, January 24, 2018 2:49 PM

Insignia NS-DWH1SS9 Specifications

General

Brand	Insignia
Model	NS-DWH1SS9
Category	Dishwasher
Language	English