INSTALLATION INSTRUCTIONS
22
www.insigniaproducts.com
Step 2: Connect the water hoses
1 Connect the water hoses to the hot and cold water faucets.
2 Tighten the hose and faucet fittings by hand until they are snug. Tighten them
an additional two-thirds of a turn with pliers or a wrench. Pull the water supply
hoses downwards to make sure that they are connected securely.
3 Place the unconnected ends of the hoses into a bucket, then turn on the
faucets connected to the water supply hoses for 10 or 15 seconds to remove
any foreign substances. Turn off the faucets.
CAUTIONS:
• Use new water supply hoses. Using old hoses can result in leakage or overflow that
can damage your property.
• Don’t connect multiple water supply hoses together to increase the length of the
hose. Hoses connected this way can leak and cause electrical shock. If a hose is too
short, replace the hose with a longer, high-pressure hose.
CAUTION:
Don’t overtighten the fittings or apply tape or sealant to the faucets or water supply
intakes. This can damage the fittings.
To Next Page
Loading...
