33
NS-FWM27W1
www.insigniaproducts.com
OPERATING INSTRUCTIONS
Step 7: (Optional) Decrease the wash time
• Press the Express button. The Express light turns on and the wash time
decreases.
Step 8: Start your washer
1 Press the Start/Pause button.
2 If you need to pause the cycle (for example to add or remove items), press and
hold the Start/Pause button for three seconds. Wait for the drum to stop, then
open the door. When you’re ready to resume washing, close the door, then
press the button again.
Notes:
• After the delay time is set, if you want to change the delay setting, press the Delay
button again until the hour you want is reached. Release the button for three
seconds.
• If you decide to cancel the delay setting, you can either turn the cycle selector or
press the Delay button until 0 is reached.
• Ideally, you should set your cycle before setting the delay time because turning the
cycle selector after you set the delay time cancels the delay function.
• You can change settings or cancel the delay start time function anytime before you
press the Start/Pause button by turning the cycle selector.
• You can’t change the delay start time after you press the Start/Pause button. If you
pressed the Start/Pause button, you can cancel the delay start time function by
pressing the Power button to turn off your washer, then pressing the button again
to turn it back on.
• You can’t change the Delay Start Time after the program has started.
Note: Express works for Normal, Perm Press, Heavy Duty, Bulky, and Active Wear
cycles.
Note: If you haven’t set a delayed start time or if the delay time has expired, your
washer starts the cycle and the Wash light turns on.
As your washer moves from stage to stage in the wash cycle, the related light turns
on (such as Rinse or Spin).
If you set a delayed start time, the Delay light turns on and your washer starts
counting down the start time.
CAUTION:
Don’t try to force the door open if:
• The drum is moving. You will damage your washer.
• The water level is above the edge of the inner tub. Water will spill on the floor.
• The water temperature is too hot. You may burn yourself.
• If you press and hold Start/Pause button for three seconds, the door won't open
because the door can't match the above conditions. You should wait until the
perfect time.
To Next Page
Loading...
