OPERATING INSTRUCTIONS
32
www.insigniaproducts.com
1 If you are using the Pre-Wash option, pour the recommended amount of
laundry detergent directly into the pre-detergent compartment (I) before
starting your washer.
2 Pour the recommended amount of laundry detergent directly into the
detergent compartment (II) before starting your washer.
3 If you’re using color-safe bleach or liquid chlorine bleach, add it with the
detergent to the detergent compartment.
4 Pour the recommended amount of liquid fabric softener into the softener
compartment . The dispenser automatically releases liquid fabric softener
at the correct time during the rinse cycle.
Step 5: Select the appropriate cycle and options for the load
• Turn the cycle selector to select a washing cycle. For information on wash
cycles, see Washer options and settings on page 34.
Step 6: (Optional) Set a delayed start time
You can program a wash cycle, then set a time when you want a wash cycle to
begin.
1 Turn the cycle selector knob to the cycle type you want.
2 Press the Delay button repeatedly to select the delay time you want. The
delay start time, in hours, appears on the display, in sequence, from 0 to 24,
then back to 0. When you reach the time setting you want, hold the Delay
button for three seconds to confirm the setting. The Delay light turns on.
3 Press and hold the Start/Pause button for three seconds to start the delay
timer.
4 To cancel the delay start time function before you save the setting, press the
Delay button until 0H appears on the display.
Notes:
• When adding color-safe bleach with detergent, both laundry products must be in
the same form (liquid).
• If you are using powder detergent, add it to the bottom of the tub before you add
the load.
CAUTIONS:
• Use the softener compartment ONLY for liquid fabric softeners.
• Don’t use the Downy Ball® in your washer.
• Don’t use liquid fabric softener that is too sticky because it may not mix with the
water sufficiently.
Note:
Your washer stores your settings in memory. If the power fails, press the Start/Pause
button when power is restored. Your washer continues the Delay function you set.
To Next Page
Loading...
