10
NS-HTTCFB8
www.insigniaproducts.com
Using ECO mode
In ECO mode, the heater automatically adjusts the mode according to the
room temperature. When the room temperature is below 64° F, the heater
operates in high power mode. When the room temperature is above 64° F
and below 72° F, the heater operates in low power mode. When the room
temperature is 72° F or above, the heater turns off.
• Press the button. The heater switches to ECO mode and the ECO
indicator lights.
Turning on the swing (oscillator) to circulate the heat
• Press swing to turn the swing function on. The swing indicator
turns on and the heater begins to oscillate. Press again to turn it
off.
Setting the timer
1 Press to set the timer. The time/temperature display turns on and
the indicator lights on the display.
2 Press the + (up) or – (down) button. The timer setting changes by one
hour each time you press the button and is shown on the display. The
maximum timer setting is 24 hours.
.
Using the body sensor
When the body sensor is on, the heater detects bodies in the area. If any
bodies are detected, the heater works normally. If no bodies are detected,
the heater stops working after two minutes, the fan turns off after 10
seconds, and the body sensor indicator light blinks. During this period,
you can set the mode and function, but the heater will not respond to the
new setting until a body is detected in the area.
• Press . The body sensor turns on and the body sensor indicator
turns on. Press it again and the body sensor turns off.
Note
If you activate the body sensor, the fan will stop swinging.
Note
• Press and hold the “+/-” button to change the number
rapidly.
• The previous timer setting will not change unless you press
the “+/-” button to reset the time.
• If you don't set the time within five seconds, or if you press
any button except “+/-”, the heater will exit the timer
function.
• When you set the timer within 1-24 hour(s), the timer
function will start (it does not show a countdown number).
When the time is complete, the heater turns off and enters
standby mode.
• If you set the timer to 0, the timer function turns off and the
heater works normally.
NS-HTTCFB8_17-0321_MAN_V1_ENG.fm Page 10 Thursday, June 15, 2017 2:09 PM
To Next Page
Loading...
Need help?
General
