9
Ceramic Tower Heater
www.insigniaproducts.com
4 Press the power button to turn the heater on. The display shows
the current room temperature in °F with the °F icon turned on. The
default temperature setting is 77° F and the heater is on low power
with the low power indicator on.
5 Press the power button to turn the heater off (go to standby mode).
When you turn the heater back on, the settings remain the same as
when you turned it off.
Increasing or decreasing the temperature setting
1 Press twice. The turns on.
2 Press the + (up) or – (down) button to increase or decrease the
temperature from 41° F to 95° F. The temperature setting changes by
1° F each time you press the button and is shown on the display.
3 Press again to confirm the change. The display returns to the
current room temperature. The heater turns on and stays on until the
set temperature is reached, then the heater, fan, and swing turn off.
Switching modes
• Press repeatedly to cycle through low, high, and fan modes. The
appropriate indicator lights as the mode is selected.
Note
• Press and hold the “+/-” button to change the number
rapidly.
• If you don't set the temperature within five seconds, or if
you press any button except “+/-”, the heater will exit the
temperature function.
• When the room temperature is below 14° F, the display
shows “LO”. When the room temperature is 104° F or higher,
the display shows “HI”. If the temperature is within that
range, the display shows the actual temperature.
• If the room temperature is higher than the temperature
setting, the heating elements and mode indicator on the
panel stop automatically and the fan continues to operate
for another 60 seconds.
• If you turn off the heater, the fan will continue to operate
for 10 seconds.
• If the room temperature is 3° F below the temperature
setting, the heating elements restart and the heating mode
shows on the display.
• When both the timer function and the desired temperature
are set, the display panel shows the timer and the room
temperature respectively every 30 seconds. If the timer is
not set, the display only shows the room temperature.
NS-HTTCFB8_17-0321_MAN_V1_ENG.fm Page 9 Thursday, June 15, 2017 2:09 PM
To Next Page
Loading...