14
NS-OTR16SS9 / NS-OTR16WH9
www.insigniaproducts.com
Cleaning and replacing the filters
Cleaning the grease filters
Clean the filters at least once a month. Never use the fan or microwave without the filters in place.
1 Pull down slightly on the tab toward the front of the microwave to remove the filter. Repeat for the other filter.
2 Soak the filter in a sink or dish pan filled with hot water and detergent.
CAUTION
DO NOT use ammonia or other alkali. They will react with the filter material and
darken it.
3 Agitate and scrub the filter with a brush to remove embedded dirt.
4 Rinse thoroughly and shake dry.
5 Replace by fitting the filter back into the opening.
Grease filters
BOTTOM
Replacing the charcoal filter
A charcoal filter is used for nonvented, recirculated installation. The filter should be changed every 6 to 12 months
depending on use.
1 Disconnect power to the microwave at the circuit breaker or by unplugging it.
2 Remove the louver mounting screws from the top center of the louver, then push down on the tabs at each end
of the louver to disengage it.
Louver mounting screws
3 Pull the louver away from the unit.
Louver
To Next Page
Loading...
