Insignia NS-RMT415 - Maintenance and Support; Resetting Remote to Factory Defaults

6
Unlocking volume controls
1 Press the mode button (TV, DVD, STB,
STREAM) for the device you want to unlock the
volume for.
2 Press and hold SETUP until your remote’s LED
blinks twice.
3 Press 9, 9, 3, then press
Vol Down .
OR
To unlock the volume for all devices, press 9, 9,
3, then press Volume Up [].
LOCKING AND UNLOCKING CHANNEL
CONTROLS
If you want to lock the channel of all four modes
to one device, deactivate Watch TV mode as
described above.
Locking channel controls to one device
1 Press and hold SETUP until your remote’s LED
blinks twice.
2 Press 9, 7, 3, then press CH .
3 Press the mode button for the type of device
you want to set up (TV, DVD, STB, STREAM).
The LED blinks twice to con rm.
Two blinks = Success
One long blink = Failure
Unlocking channel controls
1 Press and hold SETUP until your remote’s LED
blinks twice.
2 Press 9, 7, 3, then press CH -.
RESETTING REMOTE TO FACTORY
DEFAULTS
1 Press and hold SETUP until your remote’s LED
blinks twice.
2 Press 9, 7, 7.