Insignia NS-RMT415 User Manual

4
Setup method B: Direct code entry
1 Turn on your target device.
2 Press and hold SETUP until your remote’s LED
blinks twice.
3 Press the mode button for the type of device
you want to set up (TV, DVD, STB, STREAM).
The LED stays lit.
4 Enter the  rst 5-digit code for your brand from
the code list (see “TV CODE LIST” on page 10).
5 Press the (power) button to test your device.
If your device turns o and the remote’s LED
blinks twice, setup is complete.
6 If the device does not turn o , repeat steps
2-5 using the next code for your brand or use
“Setup method C: Code search.”
Setup method C: Code search
1 Turn on your target device.
2 Press and hold SETUP until your remote’s LED
blinks twice.
3 Press the mode button for the type of device
you want to set up (TV, DVD, STB, STREAM).
The LED stays lit.
4 Press digit 0 - 3 to select the device that you
wish to set up:
0 - STB/cable/streamer
1 - TV
2 - DVD/VCR
3 - Audio/receiver/sound bar
5 Press and hold OK until your device turns o .
Release the button when your device turns o
and the remote’s LED blinks twice. Setup for
that device is complete.
USING YOUR REMOTE
1 Press the mode button (TV, DVD, STB,
STREAM) for the type of device you want to
control.
2 Press the buttons applicable to that type of
device.

Insignia NS-RMT415 Specifications

General

Brand	Insignia
Model	NS-RMT415
Category	Remote Control
Language	English