EasyManuals Logo

Insignia NS-RNG24SS9 User Manual

Insignia NS-RNG24SS9
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
www.insigniaproducts.com
30
3.7 Cu. Ft. Free-Standing Gas Range for RVs
To reinstall the oven door
1 While holding the door at approximately a 45° angle, insert the hinge tongues into the slots making sure that the
notches on both sides slide into place.
2 Carefully close the door. If the door does not easily close, do not force it. Make sure that the hinges are correctly
installed.
Troubleshooting
Cook top
If the solutions in this section do not solve a problem, contact a qualified service technician or Insignia customer service.
PROBLEM PROBABLE CAUSE POSSIBLE SOLUTION
Some burners will not light Burner parts or igniter may
be wet, dirty, or misaligned
Make sure that the burner parts are clean,
dry, and correctly assembled.
Make sure that the igniters are clean and dry.
For instructions on cleaning a cook top burner, see
Cleaning the cook top burners on page 24.
Flames do not burn all
around the burner cap
Burner parts or igniter may
be wet, dirty, or misaligned
Make sure that the burner parts are clean,
dry, and correctly assembled.
Make sure that the igniters are clean and dry.
For instructions on cleaning a cook top burner, see
Cleaning the cook top burners on page 24.
Burner flames are unusually
large and yellow
Burner bezel ports are
clogged
Clean burner bezel ring ports with a straightened
paper clip, needle, or wire.
Burner ports or burner caps
are not positioned correctly
Remove and carefully re-install the burner bezels
and caps.
Cook top is being operated
with the wrong type of gas
Make sure that the type of cook top matches the LP
gas supply.
Regulator is not installed, is
faulty, or is set for the wrong
type of gas
Check the installation, replace the regulator, or set
the regulator for the correct type of gas.
Ignition sparks, but there is
no flame
Gas shut-off valve is in the
OFF position
Turn the shut-off valve to the ON position.
Igniters spark continuously
after flame ignites
Power supply polarity is
reversed
Contact a service technician to have the polarity
corrected.
Igniters are wet or dirty Dry or clean the igniters.
Notch

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Insignia NS-RNG24SS9 and is the answer not in the manual?

Insignia NS-RNG24SS9 Specifications

General IconGeneral
BrandInsignia
ModelNS-RNG24SS9
CategoryRanges
LanguageEnglish

Related product manuals