6
CAREFULLY READ THE INSTALLATION OPERA-
TING AND MAINTENANCE INSTRUCTIONS BEFORE
INSTALLING THIS APPLIANCE. INCORRECT
INSTALLATION, ADAPTATIONS OR ALTERNATIONS
COULD CAUSE DAMAGE TO PROPERTY OR PER-
SONAL INJURY. FAILURE TO COMPLY WITH THESE
INSTRUCTIONS, ABUSE RESULTING IN DAMAGE
AND IMPROPER INSTALLATION WILL VOID WAR-
RANTY AND RESPONSIBILITIES OF THE MANU-
FACTURER.
1. Carefully read this instructions booklet, as it contains
important advice for safe installation, operation a
nd
main
tenance. Keep this booklet handy in a safe
place
f
or future reference.
2. The installation instructons contained herein
are
for
the use of qualified installation and ser
vice
pers
onnel only. Installation or service by ot
her
tha
n qualified personnel may result in damage
to
the
appliance and/or injury to the operator. FAI-
LURE TO COMPLY WITH INSTALLATI
ON
I
NSTRUCTION OR IMPROPER INSTALLATION
WILL VOID WARRANTY AND RESPONSIBLITIES
OF THE MANUFACTURE.
3. The equipment warranty is not valid unless the unit
is
insta
lled, started and demonstrated under the super-
vision of a factory trained installer.
4. Switch off the appliance in the event of failure or mal-
functioning at the main circuit breaker.
Only have the appliance repaired by an Authorized Ser-
vice Center and be sure to ask for OEM original spare
parts.
B1 NOTICE FOR SHIPPING DAMAGE
• The container should be examined for dama
ge
befor
e and during unloadi
ng.
•
The freight carrier has assumed responsibility for its
safe transit and delivery.
• If damaged equipment is received, either appare
nt or
co
ncealed, a claim must be made with the deliver
ing
ca
rrier. Apparent damage or loss must be note
d on
the freight
bill at the time of delivery.
• The freight bill must then be signed by the
carrier
repres
entative (Driver). If the
bill is not signed, the
c
arrier may refuse the claim. The supply can supply
the necessary form
s.
•
A request for inspection must be made to the carrier
within 15 days if there is concealed damage or loss
that is not apparent until after the equipment is uncra-
ted. The carrier should arrange an inspection
.
•
Be certain to hold all contents plus all packing mate-
rial. Under no circumstances should a damag
ed
appliance be returned to the manufacturer without
prio
r notice and written authorization.
B2 HANDLING
Use suitable means to move the appliance: a lift truck or
fork pallet trucks (the forks should reach more than hal-
fway beneath the appliance).
B3 UNPACKING
Wear protective gloves to unpack.
Figure 1
Lift the appliance using a lift truck,
Figure 2
remove the base and position the appliance where it is
to be installed.
Figure 3
Remove the protective film and ensure that the packag-
ingmaterial is disposed of correctly in compliance with
the regulations in force in the country where the product
is to be used.
B GENERAL RECOMMENDATIONS
To Next Page
Loading...
