4
line from the dispenser so it fits into
Ik CAUTION
Property OamaJ]e;Make sure _e bondsintubinga_e
smooth andnot_nked. Don'tusepaste-type sealantson
water lineconnections.Tightencompressionfittings
snugbut don_tovertigh|en.
the cold water supply. With one hand,
support the copper line coming out
of the tank and bend the tube with
the other hand.
Do not kink, Bend tube carefully.
D When connecting to a compression
type T-fitting or valve, remove the
nut and ferrule (round brass piece)
from the fitting. Then, place the nut
followed by the ferrule over the end
of the tube coming from the
dispenser.
L_ Push the tube end all the way into
the T-fitting or valve. Hold the tube
end in position and push the terrule
down as far as it wilt go. Then,
tighten the nut over the ferrule with
your fingers. Make sure the tube
end {s going straight into the hole.
Then tighten the nut firmly with a
t/2" wrench.
5
<_'-_ _r _- way ano see n your connections are
j__ "_q/_z_-- watertight. ]f there are any leaks
_ carelutfy re-tighten alt connections,
,&CAUTION
PropertyDamage:l',!everpi_'ea r_on nnthedeliwry
of_t_ fromthespot&Su_ a r_tri_onprevents dm_ing
theexp_on c_araber&_dcoulddamagethe
[] Press valve lever down tor about 20
seconds until water freely runs out of
the spout. Hold valve open at least 60
seconds to let the water run to flush
out the lines.
Water will be cold since tank has not
been plugged in yet.
,&WARNING
Propertyi3amage:Dono|remev_or;_l|ert_e[h_m_
satetyfus& I!yoususpectthethermalfuse_sopen,
contactyourAutho_zedSerViceCenter.
Check all connections to ensure they
are tight and that there are no leaks,
then plug m _nstant hot water tank.
Allow10-15minutesfor waterto reach
targettemperature.Gurglingorhissingis
normalduringtheinitial heatingcycle.
Steamand/orhutwatercomingfromthe
spoutwithoutpressingdownon the handle
isalsonormal,If steamisstill emittedafter
setup,thermostatadjustmentsmaybe
needed(pg,11).
erLine"
1-800-558-5700
8 9
To Next Page
Loading...
