Need help?Do you have a question about the InSinkErator Hot1 and is the answer not in the manual?
Identify location, check clearance, ensure proper outlet, and confirm counter thickness.
Specifies the required hole diameter for mounting the dispenser.
Remove spout, mount dispenser through sink hole with gasket and nut.
Align spout for water flow, tighten wing nut, and reassemble spout.
Connect copper tube to T-fitting or compression valve for water supply.
Use self-piercing attachment to connect copper tube to saddle valve.
Complex installation for experienced users using a shutoff valve.
Bend and position copper line carefully, avoid kinks. Connect compression fitting.
Open valve, flush lines, check connections, and plug in dispenser.
Grounding, avoiding modification, and handling hot water risks.
Keep flammables away, inspect for leaks, use drain pan if needed.
Adjust water temperature by turning thermostat screw clockwise or counter-clockwise.
Use mild cleaners for faucet and plastic. Avoid harsh chemicals.
Unplug and drain unit for extended non-use or freezing temperatures.
Unit boiling or normal during setup; depress lever to release water.
Check unit connection, outlet, circuit breaker, and adjust thermostat.
Expansion chamber issue or blocked spout; check pressure and clean spout end.
Debris in faucet valve seat; unscrew spout end piece and clean debris.
Debris in the end piece; unscrew spout end piece and clean debris.
General| Brand | InSinkErator |
|---|---|
| Model | Hot1 |
| Category | Water Dispenser |
| Language | English |
To Next Page
