9
10
Press key to “froze” the reading, then press key or to
change the value to standard value and then press key to
confirm. At the same time the tester remind you to make thick
calibration as below:
Make thick calibration just as thin calibration.
Press key to confirm and return to main interface.
Send data to PC
1
There are 5 files (FILE1-FILE5) that can be used to store the
measurement values inside the gauge. At most 100 records can be
stored to each file. On measurement screen, press the key multiple
times to activate the【FILE name】tab as below:
Storing a reading:
Use the key to select the desired file to save the data.
After get a n ew rea ding, press key once and the
screen appear “*”. Then long press this key to save the
reading.
Long press key to save the reading.
2
Viewing stored readings:
Press key to activate the【FILE name】tab and press key
to select the desired file to view the data.
Press key to view the data saved as below:
Press key or to view all data saved.
Press key to exit.
3
Delete data
Press key when you are viewing data saved to delete that data
and the next data will show on the screen.
You can also enter the function menu to delete single file or all
files.
:
Connect instrument to the computer by using USB cable.
Memory management
1
Put the software CD into the CD-ROM, double click the “USB
Driver” to install the USB cable drive. After installation you need
enter into Device Manager to ensure the interface code. Like the
following picture it is COM4.
2
To Next Page
Loading...