Insta360 ONE RS - Initial Setup and Preparation; Battery and Charging Procedures; MicroSD Card and Waterproofing

6
Before You Start
Note: The following instructions use the 4K Boost Lens as an example.
• Ensure the battery has been assembled properly. Please connect the included
charge cable to ONE RS in case of low or depleted battery.
Note: Please use a 5V/2A power adapter to charge your ONE RS. You can also use the
official Insta360 Fast Charge Hub (sold separately).
• Before use, open the lock cover and insert a MicroSD card.
Note: Please use exFAT formatted microSD cards with the UHS-I bus interface and
Video Speed Class V30 rating (exactly this class, neither higher nor lower) to ensure
normal recording. The maximum supported storage space is 1 TB. For specific info in
supported MicroSD card models, see https://www.insta360.com/r/oners_microsd.
Note: Be sure to close the lock cover completely to
ensure the waterproofing is not affected. Align the
circular indication marks as shown on the picture. The
yellow indication mark near the lock buckle should be
covered.
1. Push the lock
buckle to the right to
open the lock cover.
2. Insert the MicroSD card (with
the label facing the front side of
the core).
Front side of the core
(without the touch
screen).