30 | support@instantpot.com | 1-800-828-7280
Care, cleaning and storage
Steam release handle
Remove the steam release handle
Pull the steam release handle up and off
the steam release pipe.
The steam release handle must be
installed before using the multicooker.
Install the steam release handle
Place the steam release handle on the
steam release pipe and press down rmly.
The steam release handle sits loosely on
the steam release pipe when installed
properly but should remain in place when
the lid is turned over.
Anti-block shield
Remove the anti-block shield
Grip the lid like a steering wheel and use
your thumbs to press rmly against the
side of the anti-block shield (pressing
towards the side of the lid and up) until it
pops off the prongs underneath.
Install the anti-block shield
Place the anti-block shield over the prongs
and press down until it snaps into position.
Do not attempt to operate the pressure
cooker without the anti-block shield
installed.
To Next Page
Loading...
