6
Extend and Secure the Tow Bar
1.
Place the trailer
on its side with the
tow bar on top.
2.
Remove the
locking pin from
the bracket.
3.
Rotate the tow bar
until it rests on the
front end of the
frame.
4.
Insert the locking
pin through both the
bracket and tow bar.
5.
Slide the metal
safety loop onto the
locking pin. Check
that it is securely
in place.
Safety
loop
Locking
pin
Attach the Canopy
1.
Place the canopy over the canopy frame.
2.
Fasten the snaps on the front, back and top of
the canopy to the side walls (6 snaps total).
3.
Attach the hook and loop fasteners on the
canopy to the strips on the front and back
frame walls.
Attach the Bumper Guard
1.
Align the holes of the plastic bumper with the
holes on the top, right corner of the frame.
Be sure the wall frame ts into the inset of the
plastic bumper.
2.
Using a phillips
head screwdriver,
fasten the screws
through the holes
of the plastic
bumper and frame.
Snap
Snap
Canopy
Unroll rain protector
from elastic (if needed)
Plastic bumper inset
Tow bar
Locking
pin
Front frame
Right front
frame corner
Wall frame
Hook
and loop
Hook
and loop
Snap
Screw
Screw
To Next Page
Loading...
Need help?
General
