InStep QUICK N EZ - Attach Rear Wheels; Insert Safety Flag

7
Attach the Rear Wheels
1.
Insert the rear wheel axle into the rear wheel
bracket hole.
2.
Push the wheel into the bracket until you hear
the axle click into place.
Wheel axle
Rear wheel
bracket
3.
Pull rmly on the wheel to ensure the locking
mechanism is engaged. Repeat these steps
on the opposite side.
WARNING!
Click
Rear wheels that are not securely locked in place
may fall off the trailer and cause serious injury
or death. Always check the wheels are securely
locked in place before use.
Release lever
for rear wheels
Note: shown from underside of
the frame.
Important! The safety ag is an important safety
feature that warns others a trailer is present and
on the bicycle. Always have the safety ag on the
trailer when in use.
Insert the Safety Flag
Flag pole sleeve
1.
Assemble the ag pole
sections by sliding the top
half of the pole into the
opening of the bottom half
of the pole.
2.
Slide the pole through the
hole and into the sleeve
located near the rear corner.