3
1. Warranty Claim
You can find the serial number on the rear panel of this unit. In
case of warranty claim, please report this number.
2. Recording Copyright
Recording of copyrighted material for other than personal use is
illegal without permission of the copyright holder.
3. AC Fuse
The fuse is located inside the chassis and is not user-serviceable. If
the power does not come on, contact your Integra/Onkyo autho-
rized service station.
4. Care
From time to time you should wipe the front and rear panels and
the cabinet with a soft cloth. For heavier dirt, dampen a soft cloth
in a weak solution of mild detergent and water, wring it out dry,
and wipe off the dirt. Following this, dry immediately with a clean
cloth. Do not use rough material, thinner, alcohol or other chemi-
cal solvents or cloths since these could damage the finish or re-
move the panel lettering.
5. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
The voltage of the available power supply differs according to
country or region. Be sure that the power supply voltage of the
area where this unit will be used meets the required voltage (e.g.,
AC 120 V, 60 Hz) written on the rear panel.
For Canadian models
For models having a power cord with a polarized plug:
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
Modele pour les Canadien
Sur les modèles dont la fiche est polarisée:
ATTENTION:
POUR ÉVITER LES CHOCS ÉLECTRIQUES,
INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE
DANS LA BORNE CORRESPONDANTE DE LA PRISE ET
POUSSER JUSQU’AU FOND.
Precautions
Supplied accessory
Check that the following accessory is supplied with the ADM-2.1.
Power cord × 1
Features
WIDE RANGE AMPLIFIER TECHNOLOGY (WRAT)
WRAT virtually eliminates the adverse effects of counter-
electromotive force by:
1) applying an uncommonly low amount of NFB (negative feed-
back),
2) using carefully selected, high-tolerance, wide range parts in all
critical sections, and
3) incorporating innovative circuit topology based upon decades
of high-end amplifier design experience — the final result is flat
response beyond 100 kHz.
AUTO POWER ON/OFF FUNCTION
You can turn on and off the ADM-2.1 via a signal input to the
AUDIO IN jacks or 12V TRIGGER IN jack.
AUDIO IN/OUT LINK FUNCTION
The signal inputs from the AUDIO IN jacks are output from the
AUDIO OUT jacks. When used as a 2 channel amplifier in a multi
room configuration, you can connect several ADM-2.1s to enjoy
the same source in several rooms.
#US_ADM-2.1_02-03.p65 8/25/00, 6:22 PM3
To Next Page
Loading...
Need help?
Amplifier Section
