134
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
7. Multi Zone
1. Zone 2
Change the settings for Zone 2.
Setting Item Default Value Setting Details
Output Level Fixed Select whether to adjust the volume on the pre-
main amplier in the separate room or on this unit
when outputting to Zone 2.
"Fixed": Adjust on the pre-main amplier in the
separate room
"Variable": Adjust on this unit
Maximum Volume O Set the maximum value for Zone 2 to prevent the
volume from becoming too loud. Select a value
from "O", and "50" to "99".
Power On Volume Last Set the Zone 2 volume level of when the unit is
turned on. Select a value from "Last" (Volume level
when the unit was turned o), "Min", "1" to "99" and
"Max".
• You cannot set a higher value than that of
"Maximum Volume".
2. Zone 3
Change the settings for Zone 3.
Setting Item Default Value Setting Details
Maximum Volume O Set the maximum value for Zone 3 to prevent the
volume from becoming too loud. Select a value
from "O", and "50" to "99".
Power On Volume Last Set the Zone 3 volume level of when the unit is
turned on. Select a value from "Last" (Volume level
when the unit was turned o), "Min", "1" to "99" and
"Max".
• You cannot set a higher value than that of
"Maximum Volume".
3. Remote Play Zone
Change the settings for remote play.
Setting Item Default Value Setting Details
Remote Play
Zone
Auto When playing with AirPlay or Spotify Connect,
or when using the Music Server function to play
remotely from your PC, you can set whether to play
in the main room (where this unit is located) or in a
separate room (ZONE 2/ZONE 3).
"Auto": When the main room input is NET, music
is played in the main room. When the separate
room input is NET and the main room input is other
than NET, then the music is played in the separate
room.
"Main", "Zone 2", "Zone 3": Select when limiting the
play zone to a particular room. For example, when
playing only in the separate room, select "Zone 2"
or "Zone 3".
• This function may not work if playback is already
proceeding with the same network function.
To Next Page
Loading...
Need help?
General
