Why is there no sound or very quiet sound on my Integra DTR-30.7?
If there is no sound or the sound is very quiet, ensure that you have selected the correct input for your player and that muting is not enabled.
How to fix out of sync video and audio on Integra DTR-30.7?
If the video and audio are out of sync, it might be because the video is delayed relative to the audio, depending on your TV's settings and connections. You can adjust this in 'Step 3: Before starting the procedure Playing Back', '7 Quick Setup Menu', 'A/V Sync'.
What to do if there is no picture on my Integra DTR-30.7 Receiver?
If there is no picture, ensure that you have selected the correct input. To display video from the connected player on the TV screen, while holding down CBL/SAT on the main unit, press zOn/Standby on the main unit.
How to fix blurry or unclear TV image on Integra Receiver?
If the TV image is blurry or unclear, it is possible that the power cord or connection cables of the unit may have interfered. In that case, keep distance between TV antenna cable and cables of the unit.
General| Channels | 7.2 |
|---|---|
| HDMI Outputs | 2 |
| 4K Support | Yes |
| 3D Support | Yes |
| Dolby Atmos | Yes |
| DTS:X | Yes |
| Zone 2 | Yes |
| Bluetooth | Yes |
| THX Certified | Yes |
| Network Connectivity | Ethernet, Wi-Fi |
| Streaming Services | Pandora, Spotify, TuneIn |
| Multi-Room Audio | Yes |
| Dimensions | 435 x 173 mm |
| Frequency Response | 10 Hz-100 kHz (+1 dB, -3 dB) |
| THD | 0.08% |
| Input Sensitivity and Impedance | 200 mV/47 k-Ohms (Line) |
| Signal-to-Noise Ratio | 106 dB |
| Video Inputs/Outputs | Component: 2 in / 1 out |
| Audio Inputs/Outputs | Optical, Coaxial |
| USB | Yes (Front) |
| Power Output | 100 W per channel (8 Ohms, 20 Hz-20 kHz, 0.08% THD, 2 Channels Driven, FTC) |
| Weight | 24.7 lbs (11.2 kg) |
To Next Page
