Need help?Do you have a question about the Integra DTR-70.3 and is the answer not in the manual?
General| Channels | 9.2 |
|---|---|
| HDMI Inputs | 8 |
| HDMI Outputs | 2 |
| Audio Formats Supported | Dolby Atmos, DTS:X, Dolby TrueHD, DTS-HD Master Audio |
| Network Connectivity | Ethernet, Wi-Fi |
| Room Calibration | Audyssey MultEQ XT32 |
| THX Certified | Yes |
| 4K Upscaling | Yes |
| Internet Radio | Yes |
| USB Port | 1 (Front) |
| Video Formats Supported | 4K, HDR10, Dolby Vision |
| Streaming Services | Spotify, Pandora, Tidal, Deezer |
| Frequency Response | 5Hz-100kHz |
| Input Sensitivity/Impedance | 200mV/47k ohms |
| Video Inputs/Outputs | Component: 2 In, 1 Out |
| Audio Inputs/Outputs | 2 x Optical, 2 x Coaxial |
| Network Features | DLNA |
| HDMI Version | 2.0 |
Reduces risk of fire or electric shock. Do not expose to rain or moisture.
Reduces risk of electric shock. Do not remove cover. Refer servicing to qualified personnel.
Important information about voltage, power cord accessibility, and unplugging for extended periods.
Lists HDMI, digital, analog, and network/USB connection ports and features.
Identifies buttons and ports on the front panel for North American and Australian models.
Details connection terminals and jacks on the rear panel for the DTR-80.3.
Instructions for operating the AV receiver using the remote control, including mode selection.
Illustrates speaker connections for 9.2-channel playback and details terminal types.
Important safety and connection tips, including impedance, polarity, and cable handling.
Shows default assignments for HDMI inputs and outputs for various components.
Steps to turn on the AV receiver and put it into standby mode.
Steps for playing sources using the remote controller or AV receiver's front panel.
Guides on tuning using auto-seek and manual frequency entry modes.
Guides on using Audyssey MultEQ XT32 for automatic speaker configuration and room correction.
Step-by-step guide on using the remote controller to select, change, and confirm settings.
Step-by-step guide to update AV receiver firmware using a wired network connection.
Troubleshooting for AV receiver not turning on, turning off unexpectedly, or protection circuit activation.
Solutions for no sound, quiet sound, or issues with digital input sources and speaker connections.
Details connection formats: composite, S-Video, PC IN, Component, HDMI, and their signal flow.
Diagram and explanation of connecting the AV receiver to a router via Ethernet for network access.
Details power output, dynamic power, THD+N, damping factor, and input sensitivity.
To Next Page
