Why is my Integra DTR-70.6 making noise?
If you're experiencing noise issues with your Integra Receiver, avoid bundling analog audio (RCA) cables with power cords or speaker cables, as this can degrade audio performance. Additionally, try repositioning your cables, as the analog audio cable might be picking up interference.
What to do if there is no sound with a certain signal format on Integra Receiver?
If you are not getting sound with a certain signal format, and you are listening to Dolby Digital and/or DTS sound, a digital connection is necessary. Check the digital input terminal setting. If the connection is different from the default, re-setting is necessary. Also, check the digital audio output setting on the connected component. On some game consoles, such as those that support DVD, the default setting is OFF.
How to fix Integra DTR-70.6 that won't turn on?
If your Integra Receiver won't turn on, ensure all speaker cables and input sources are properly connected. Disconnect the power cord for 1 hour, then reconnect and try turning it on again. If it turns off again, unplug the power cord and contact your Integra dealer.
Why is there no subwoofer sound on my Integra Receiver?
If the subwoofer on your Integra Receiver isn't producing sound, and you are playing source material that contains no information in the LFE channel, the subwoofer will not produce sound. Make sure the speakers are configured correctly.
What to do if there is no sound with Dolby Atmos signal format on Integra DTR-70.6 Receiver?
If you're not getting sound with Dolby Atmos on your Integra Receiver, make sure the surround back, height, or wide speakers are connected and configured correctly in the "Speaker Configuration". Also, ensure the input signal is in the Dolby Atmos format.
Why do only the front speakers produce sound on my Integra Receiver?
When the Stereo or Mono listening mode is selected, only the front speakers and subwoofer produce sound. Make sure the speakers are configured correctly.
Why can't I hear the beginning of audio received by an HDMI IN on my Integra DTR-70.6?
The Integra Receiver might take longer to identify the format of an HDMI signal than it does for other digital audio signals, audio output may not start immediately.
General| Audio Channels | 9.2 |
|---|---|
| Total Harmonic Distortion | 0.08% |
| HDMI Outputs | 2 |
| Dolby Atmos | Yes |
| DTS:X | Yes |
| Input Sensitivity and Impedance | 200 mV / 47 kΩ |
| Video Frequency Response | 5 Hz - 100 MHz |
| Power Supply | AC 120 V, 60 Hz |
| Network Connectivity | Ethernet, Wi-Fi |
| Bluetooth | Yes |
| Frequency Response | 5 Hz - 100 kHz |
| HDMI Inputs | 8 |
| Speaker Impedance | 4 Ohms - 16 Ohms |
| Component Video PB/CB Signal | 0.7Vp-p |
| Component Video PR/CR Signal | 0.7Vp-p |
| Dimensions (W x H x D) | 43.5 x 17.5 x 38.5 cm |
| Audio Inputs/Outputs | Phono |
| Signal to Noise Ratio | 106 dB (Line, IHF-A) 80 dB (Phono MM, IHF-A) |
| Video Input Sensitivity and Output Level | 1.0 Vp-p / 75 Ohms (Component Video) |
| Component Video Y Signal | 1.0 Vp-p |
To Next Page
