Frequency band selection / programming
- 12 -
English
Frequency Band Selection / Programming
The radio must be programmed and used exclusively on a frequency band allowed in the
country where the product is used. It is possible to program a different frequency band, as per
the following procedures :
1) Switch off the radio.
2) Press and hold the EMG (1) key while turning on the radio, using the OFF/VOL (11)
knob.
3) The current country code (G) will blink on the LCD display (2 digits).
4) Now select the desired new country code, using the channel selector knob (6).
5) Shortly press the EMG (1) key to confirm.
Table of Restrictions on the Use of CB Transceivers
The following information are to be considered only just as an indication. They are believed to
be correct at the time of printing this operating manual. It is however the user’s responsibility to
check that, in the country where radio is used, the regulations for the use of CB transceivers
have not been modified. User is therefore suggested to contact the local dealer or local
authority, in order to check the current regulations for the use of CB transceivers, before
operating this product. The manufacturer does not take any responsibility if the product is used
in violation of the regulations of the country where the product is used.
Addendum (Updated information on national restrictions)
BELGIUM, UK, SPAIN, SWITZERLAND
In order to use this transceiver in Belgium, UK, Spain and Switzerland, residence must have an
individual licence. Users coming from abroad may freely use the radio in FM mode, while in
order to use it in AM mode they must hold a licence released in their own country.
ITALY
Foreigners arriving in Italy must get an Italian authorization.
AUSTRIA
Austria does not allow using multi standard programmable CB radios. It is recommended
to carefully follow this directives and not to use the product in the Austrian territory.
GERMANY
Along some border areas in Germany, the radio can not be used as a base station from
channel 41 to channel 80. Refer to local authority (notification office) for details.
To Next Page
Loading...
