17
2-6 Connectors, Headers
2-6-1 Connectors
(1) Power Connector: ATX (20-pin block)
ATX Power Supply connector. This is a new defined 20-pins connector that
usually comes with ATX case. The ATX Power Supply allows to use soft
power on momentary switch that connect from the front panel switch to 2-pins
Power On jumper pole on the motherboard. When the power switch on the
back of the ATX power supply turned on, the full power will not come into the
system board until the front panel switch is momentarily pressed. Press this
switch again will turn off the power to the system board.
PIN ROW2 ROW1
1 3.3V 3.3V
2 -12V 3.3V
3 GND GND
4 Soft Power On 5V
5 GND GND
6 GND 5V
7 GND GND
8 -5V Power OK
9 +5V +5V (for Soft Logic)
10 +5V +12V
Pin 1
(2) PS/2 Mouse & PS/2 Keyboard Connector: KB/MOUSE
The connectors for PS/2 keyboard and PS/2 Mouse.
(3) USB Port connector: USB
The connectors are 4-pins connector that connect USB devices to the system
board.
(4) LAN Port connector: LAN (Only for 630TCF)
This connector is standard RJ45 connector for Network connector.
(5) Parallel Port Connector (25-pin female): PRINT
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The
On-board Parallel Port can be disabled through the BIOS SETUP. Please refer
to Chapter 3 “INTEGRATED PERIPHERALS SETUP” section for more
detail information.
(6) VGA Connector (15-pin female): VGA
(7) Audio and Game Connector : GAME
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC and a 15-pin
D-Subminiature Receptacle Connector for joystick/MIDI Device.
To Next Page
Loading...
