37
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default) Initial display power management signaling.
Blank Screen This option only writes blanks to the video buffer.
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
PM Wake-Up Events
Please refer to section 3-8-1
3-8-1 PM Wake up Events
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
PM Wake Up Events
Item Help
IRQ [3-7,9-15],NMI Enabled
IRQ 8 Break Suspend Disabled
Ring Power Up Control Disabled
MACPME Power Up Control Disabled
PCIPME Power Up Control Disabled
KB Power ON Password Enter
Power Up by Alarm Disabled
x Month Alarm NA
x Day of Month Alarm 0
x Time (hh:mm:ss) Alarm 0 : 0 : 0
Menu Level >>
↑↓→←
Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Ring Power Up Control
During Disabled, the system will ignore any incoming call from the modem. During
Enabled, the system will boot up if there’s an incoming call from the modem.
MACPME Power Up Control
During Disabled, the system will ignore any incoming call from the EtherNet controller.
During Enabled, the system will boot up if there’s an incoming call from the EtherNet
controller.
To Next Page
Loading...
Need help?
General
