IDE Connector
(11) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure
two hard disks to be both Masters using one ribbon cable on the primary IDE
connector and another ribbon cable on the secondary IDE connector.
Secondar
IDE Connector
Pin 1
•
Two hard disks can be connected to each connector. The first HDD is referred
to as the “Master” and the second HDD is referred to as the “Slave”.
•
For performance issues, we strongly suggest you don’t install a CD-ROM or
DVD-ROM drive on the same IDE channel as a hard disk. Otherwise, the system
performance on this channel may drop.
2-6-2 Headers
(1) COM2 Headers (10-pin block): COM2
This board has another serial port COM2, it come with cable providing serial
port COM2.
COM2
Pin 1
Note: Orient the read marking on the
COM2 ribbon cable to pin 1
(2) USB Port Headers (10-pin block): USB2
To Next Page
Loading...
