Installing and Replacing Desktop Board Components
35
Removing DIMMs
To remove a DIMM, follow these steps:
1. Observe the precautions in "
Before You Begin" on page 23.
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the AC power cord from the computer.
4. Remove the computer’s cover.
5. Gently spread the retaining clips at each end of the DIMM socket. The DIMM pops
out of the socket.
6. Hold the DIMM by the edges, lift it away from the socket, and store it in an
anti-static package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the DIMM
sockets.
8. Replace the computer’s cover and reconnect the AC power cord.
Connecting the Diskette Drive Cable
The diskette drive cable can be used to connect a single diskette drive to the Desktop
Board.
For correct function of the cable:
1. Observe the precautions in "
Before You Begin" on page 23.
2. Attach the cable end labeled P1 to the diskette drive connector on the Intel
Desktop Board (
Figure 16, A).
3. Attach the cable end labeled P2 to the diskette drive (Figure 16, B).
To Next Page
Loading...
Need help?
General
