Installing and Replacing Desktop Board Components
31
Installing and Removing a Processor
Instructions on how to install the processor on the Desktop Board are given below.
Installing a Processor
CAUTION
Before installing or removing a processor, make sure the AC power has been removed
by unplugging the power cord from the computer; the standby power LED should not
be lit (see Figure 4 on page 25). Failure to do so could damage the processor and the
board.
T
o install a processor, follow these instructions:
1. Observe the precautions in "Before You Begin" on page 27.
2. Unlatch the
processor socket lever by pushing it down and away from the socket
(Figure 7, A, B).
Figure 7. Unlatch the Socket Lever
To Next Page
Loading...
