Raptor AT – Installation Guide
56
Table D-1 Watchdog Timer Selection
Watchdog
Type
JP10
1-2
JP10
3-4
JP10
5-6
Hardware Closed Open Open
Disabled* Open Closed Open
Software Open Open Closed
* Manufacturer's Settings.
Table D-2 Watchdog Time-out Selection
Watchdog
Timeout
JP8
1-2
JP8
2-3
JP8
3-4
1200 ms* Closed Open Open
600 ms Open Closed Open
150 ms Open Open Closed
* Manufacturer's Settings.
Table D-3 Watchdog Address Selection
Watchdog
Address
JP6
1-2
JP6
2-3
110h* Closed Open
310h Open Closed
* Manufacturer's Settings.
Post Code Display
The POST code display is a device implemented on the Raptor AT to
help on failure diagnostics. A POST code is transmitted by the BIOS
during the POST (Power On Self Test). It is a number that refers to the
state or test condition of a circuit or group of circuits. Knowing the
results of these tests (hence the POST code) can be very important in
debugging a system.
To Next Page
Loading...
