User Guide for NUC8i7BEHGA, NUC8i5BEHFA and NUC8i3BEHFA
7
4. Secure the drive into the drive bay with the four screws that were used in step 1. Set the drive
bay bracket down inside the chassis (C).
Close the Chassis
After all components have been installed, close the Intel NUC chassis. Intel recommends this be
done by hand with a screwdriver to avoid over-tightening and possibly damaging the screws.
Attach and Use the VESA Bracket (Optional)
Follow these instructions to attach and use the VESA mount bracket:
To Next Page
Loading...
Need help?
General
