35
This setting allows you to choose IDE and AHCI.
3-7-2 Onboard Device Function
Phoenix – AwardBIOS CMOS Setup Utility
Onboard Device Function
Item Help
Onboard PCIE LAN Controller Enabled
Onboard PCIE LAN BootROM Disabled
High Definition Audio Enabled
USB Host Controller Enabled
USB 2.0 Controller Enabled
USB Keyboard Legacy Support Disabled
USB Mouse Legacy Support Disabled
USB Storage Legacy Support Disabled
*** USB Mass Storage Device Boot Setting ***
Menu Level >>
↑↓→←
Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Onboard PCIE LAN Controller
Setting to [Enabled] allows the BIOS to auto-detect the LAN controller and enable it. Setting
options:[ Enabled] and [Disabled] .
High Definition Audio
The selection for you to choose the embedded Audio function or 3
rd
party audio interface
installed. The settings are: Enabled and Disabled.
USB 2.0 Controller
This setting allows you to enable/disable the onboard USB controller. Selecting [Enabled]
enables the system to support USB 2.0 spec. setting options:[Disabled],[Enabled].
USB Keyboard/Mouse/Storage Support
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have
a USB keyboard. The settings are: Enabled, Disabled.
3-7-3 Onboard Super IO Function
Phoenix – AwardBIOS CMOS Setup Utility
Onboard Super IO Function
Item Help
Onboard FDD Controller Enabled
UART1 Resources Select 3F8/IRQ4
UART2 Mode Select Normal
IR Duplex Mode Half
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP
ECP Mode Use DMA 3
Menu Level >>
↑↓→←
Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Onboard FDD Controller
Select Enabled if your system has a floppy disk driver(FDD) installed on the system board
and you wish to use it. If you install add-on FDD or the system has no floppy drive, select
Disabled in this field. The settings are: Enabled and Disabled.
UART2 Mode Select
This item allows you to determine which Infrared(IR) function of the onboard I/O chip.
IrDA Duplex Mode
This field is available when UART Mode is set to either ASKIR or IrDA. This item enables
you to determine the infrared function of the onboard infrared chip. The options are Full and