- 13 -
Check “Save settings.”
Check “Reboot device.”
The reboot takes about 25 seconds, after which you will be redirected to GuestGate’s login
page when the reboot is completed.
NOTE:
The interface is designed to let you make changes on all configuration screens without
saving each change individually. Once you are done programming GuestGate, you need to
click “Exit” and reboot the device.
The changes will only take effect after GuestGate has been rebooted. Closing the Web
browser without saving the configuration changes will result in a loss of the changed
configuration.
If you have successfully performed the above steps, you can skip the next section.
To Next Page
Loading...
