b. Connect all cables
b1. Power over Ethernet (PoE)
1. Using a standard RJ-45 network cable, connect the dome camera to a
IEEE802.3af compliant PoE switch or PoE injector
b2. Without Power over Ethernet (PoE) connection
1. Connect the power adaptor to the dome camera
2. Using a standard RJ-45 network cable, connect the camera to a normal
Ethernet Switch or Router
c. Access the camera
Start the IP Installer application to set up the camera. More information
can be found in the user manual on the installation CD.
To Next Page
Loading...
